SOUDAL 750ML GUN GRADE SPRAY INSULATION - 800793

Availability: in stock Many in stock Out of stock You can purchase this product but it's out of stock

SOUDAL 750ML GUN GRADE SPRAY INSULATION - 800793

€19.99

DESCRIPTION

PU gunfoam

SPRAYABLE INSULATION FOAM is a ready-to-use, single component, self-expanding polyurethane sprayfoam for insulating all types of substrates to improve thermal insulation and reduce the risk of thermal bridges. The canister is provided with a thread so it can be used on a gun. With accompanying spray nozzle, SPRAYABLE INSULATION FOAM can be used for horizontal and vertical application to level uneven and hard to reach surfaces.

Applications

Covering of all types of surfaces to improve thermal insulation
Insulating all inconvenient or hard to reach places in construction applications, where the use of traditional insulation materials is more difficult
Suitable as insulation on all usual building substrates (such as concrete, masonry, stone, wood, EPS, drywall, most metal sheeting, gypsum boards, hard PVC, etc)
Sealing of doors, lintels, walls, ceilings and other construction parts to reduce the risk of thermal bridges
Insulating pipes, attics, cellars, balconies, garages, tanks and vessels

Featured properties

Excellent initial bonding onto surface
Good adhesion on all surfaces (except PE, PP and PTFE)
One foam can of 700 ml covers up to 1 m² of insulation (ca. 2 cm layer after curing)
Suitable for vertical and horizontal applications
Excellent thermal insulation, thermal conductivity of 0,036 W/m.K.
Reduces the risk of thermal bridges
Remains flexible, does not become brittle
Levels uneven and hard to reach surfaces
Sealing all hard to reach parts in construction applications
Less than 0,1% free diisocyanate content

Instructions

Prior to using the product, cover all adjacent areas for protection against soiling. Good ventilation must be ensured for indoor use. Wear protective goggles and gloves. Attach the application nozzle on the tip of the gun. Shake the aerosol can for at least 20 seconds. Fit the gun on the adapter. Surface should be free from grease and dust. Moisten surfaces with a water sprayer prior to application. For non-conventional substrates a preliminary adhesion test is recommended. Rotate the nozzle as needed (for vertical or horizontal application). Foam output can be adjusted by the screw at the back of the gun. Apply the foam from a distance of 30-40 cm from the surface. The application distance will determine the width of the application area. The foam will expand twice the thickness of what is sprayed out. Do not apply more than three layers of around 1 cm at once, or do not exceed a thickness of 2,5 cm at once. If more layers are needed, wait for approx. 30 minutes to apply the next layer. Moisten after each layer. Clean the spray nozzle, repeat shaking of the can after periods of non-use. Fresh foam can be removed using Soudal Gun & Foamcleaner or acetone. Prior to using the Gun & Foamcleaner, test whether surfaces are affected or not. Especially plastics and lacquer or paint layers can be sensitive to this. Cured foam can only be removed mechanically or with Soudal PU Remover.